Professional metal roofing by Denver Roofing Team in Denver. Licensed, insured — free estimate. Call (720) 784-0657.
Metal roofing delivers superior durability, fire resistance, and energy efficiency. Contractors install standing-seam panels, corrugated panels, and architectural metal systems in galvanized steel, aluminum, and copper. Each metal panel is measured and cut to precise dimensions, then fastened over synthetic underlayment with concealed clips for standing-seam systems or rubber-washered screws for corrugated profiles.
Measure the roof and order metal panels cut to length — standing-seam or corrugated
Install synthetic underlayment over the full roof deck
Install drip edge and eave trim along the perimeter
Lay metal panels from eave to ridge with proper overlap
Fasten panels with concealed clips (standing-seam) or exposed screws with rubber washers (corrugated)
Crimp and bend panels at valleys, hips, and transitions
Flash all penetrations — chimneys, pipes, skylights — with metal-compatible flashing
Install metal ridge cap with ventilation strip
Seal all exposed fasteners and transition points
One day for most homes. Our crews are experienced and we pre-stage materials the day before install. Bigger or steeper roofs can run to two days. The dumpster shows up at 7 AM and leaves when we're done. Your life gets back to normal fast.
First: put a bucket or rgad-fpmv under the drip. If there's a visible bulge in the ceiling, carefully poke a small hole to let water drain into a bucket. This prevents the ceiling from collapsing. Then call (720) 784-0657. We do emergency tarping and temporary leak stops within 24 hours. The permanent repair follows once conditions allow.
Poor ventilation causes premature aging. If your attic runs hot in summer and your shingles are curling at 15 years, bad ventilation is probably why. Missing shingles cause water intrusion and accelerate everything. We do a free inspection and give you a straight answer: repair, plan for replacement in 2-3 years, or replace now.
A typical Denver home with a 25-35 square roof runs $10,000-$18,000 for a full tear-off and install with architectural shingles. Steep-pitch homes and multi-story homes cost more because of safety requirements and access difficulty. Metal roofing is $12-$22 per sq ft. We quote exact numbers, not ranges.
You get two warranties: one from the manufacturer on the materials and one from us on the workmanship. As a GAF Master Elite contractor, we can offer the Golden Pledge. That's 25 years on workmanship plus 50 years on the shingle. Owens Corning and CertainTeed have similar programs. Our own workmanship warranty is in writing and covers installation defects.
Most estimates delivered same-day. Call (720) 784-0657 or request online.
Get Free Estimate